Cabletron Systems SWPIM-DDS Installation Manual page 23

LNK
STS
Figure 1-1 Installing the SWPIM-DDS into the Host Platform
7. Install the SWPIM-DDS in the host platform by aligning the
SWPIM-DDS with the rail guides in the host platform and sliding it in.
Take care that the SWPIM-DDS slides in straight and properly
engages the backplane host connector. Do not force the device.
8. Fasten the SWPIM-DDS with the thumbscrew.
9. Replace power to the host platform, if neccessary. Check to see that
the host platform LED indicators go to their normal configuration. If
they do not, remove the SWPIM-DDS from the host platform and
contact Cabletron Systems.
Do not connect any WAN cables until the SWPIM-DDS has
!
been configured in software. The phone company may shut
CAUTION
down a line that has an unconfigured connection on it.
SWPIM-DDS Installation Guide
Rail Guides
SWPIM-DDS
Installing the SWPIM-DDS
Host Platform
40
20
View of Host Connector End
of the SWPIM-DDS
Thumbscrew
SWPIM-DDS
Network Connector End
21
1
3036_1
1-3