Table of Contents
Advertisement
INSTALLATION REQUIREMENTS AND SPECIFICATIONS
•
A USA standard 3 prong power receptacle must be located
within 2.13 m (7 ft.) of the site.
•
The temperature of the location must be maintained between
5 and 40 C (41 to 104 F). Temperature changes of greater
than 10 C (18 F) per hour must not occur.
2.2 MMAC-M5FNB CONFIGURATION GUIDELINES
The MMAC-M5FNB has four slots that accept media interface
modules when the hub is configured with dual power supplies, and five
MIM slots when the hub is configured with one power supply. (The
slots are numbered from right to left; slot #1 is a half-width slot that is
reserved for a management module.) Cabletron Systems management
modules are equipped with a firmware-based management tool called
Local Management, which lets you control the MMAC MIMs.
Management modules are also SNMP compliant, which means that an
MMAC equipped with a management module can be managed
remotely by SNMP management software such as Cabletron Systems'
Remote LANVIEW
Manager, or any one of the SPECTRUM
management products.
You can combine Token Ring, Ethernet, and FDDI MIMs in the same
MMAC; be sure to consult the appropriate management module and
MIM installation guides for detailed setup information.
2.3 OPERATING SPECIFICATIONS
The following lists the specifications for the MMAC-M5FNB enclosure
and for the MMAC-M5PSM. Cabletron Systems reserves the right to
change these specifications without notice.
Page 2-2
®
/Windows, Remote LANVIEW
®
for SunNet
®
for Open Systems suite of
Advertisement
Table of Contents
