Welbilt FRYMASTER FilterQuick FQE30 Installation, Operation And Maintenance Manual page 3

Improper installation, adjustment, maintenance or service, and unauthorized alterations or modifications can cause
property damage, injury, or death.
installing or servicing this equipment.
No structural material on the fryer should be altered or removed to accommodate placement of the fryer under a
hood. Questions? Call the Frymaster Service Hotline at 1-800-551-8633.
Adequate means must be provided to limit the movement of this appliance without depending on or transmitting
stress to the electrical conduit. A restraint kit is provided with the fryer. If the restraint kit is missing contact your
local KES.
All fryers shipped without factory supplied cords and plug assemblies must be hardwired using flexible conduit to
the terminal block located on the rear of the fryer. These fryers should be wired to NEC specifications. Hardwired
units must include installation of restraint devices.
No warranty is provided for any Frymaster fryer used in a mobile or marine installation or concession. Warranty
protection is only offered for fryers installed in accordance with the procedures described in this manual. Mobile,
marine or concession conditions of this fryer should be avoided to ensure optimum performance.
The front ledge of the fryer is not a step! Do not stand on the fryer. Serious injury can result from slips or contact
with the hot oil.
Do not store or use gasoline or other flammable liquids or vapors in the vicinity of this or any other appliance.
Do not spray aerosols in the vicinity of this appliance while it is in operation.
Keep all items out of drains. Closing actuators may cause damage or injury.
The crumb tray in fryers equipped with a filter system must be emptied into a fireproof container at the end of frying
operations each day. Some food particles can spontaneously combust if left soaking in certain shortening material.
Do not bang fry baskets or other utensils on the fryer's joiner strip. The strip is present to seal the joint between the
fry vessels. Banging fry baskets on the strip to dislodge shortening will distort the strip, adversely affecting its fit. It
is designed for a tight fit and should only be removed for cleaning.
This fryer has a power cord (three-phase) for each frypot. Prior to movement, testing, maintenance and any repair on
your Frymaster fryer; disconnect ALL electrical power cords from the electrical power supply.
This appliance must be connected to a power supply having the same voltage and phase as specified on the rating
plate located on the inside of the appliance door.
All wiring connections for this appliance must be made in accordance with the wiring diagram(s) furnished with the
appliance. Refer to the wiring diagram(s) in the rear of this manual when installing or servicing this equipment.
DANGER
Read the installation, operating, and service instructions thoroughly before
DANGER
DANGER
NOTICE
CAUTION
DANGER
DANGER
DANGER
DANGER
DANGER
WARNING
DANGER
DANGER
WARNING
ii