Bernini Greta Flower Spitter Owner's Manual

CONTENTS:
Main Spitter Unit
GRETA FLOWER SPITTER DIAGRAM:
Clip
"Note: Minimum
water level is
2 inches above
the Water Pump"

ASSEMBLY:

1. Connect Water Pump Tube to the Main Spitter Unit (Flower Stem). If you have trouble connecting the Water Pump Tube to the Flower
Stem of the Main Spitter Unit, you may apply a small amount of soapy water to the Water Pump Tube where it meets the Flower Stem
(Figure 1).
2. Connect the Water Pump Tube to the Water Pump (Figure 2).
3. Choose a water-tight planter or container (not included).
4. Secure the Power Cord by attaching it to the Cord Clamp and tightening the clamp by lightly squeezing both tabs (Figure 3 & 4).
5. Insert and clip (Clip is located on the back of the Flower; Figure 5 & 6) the assembled Fountain Spitter onto your planter/container.
6. Fill planter/container with water. (See Greta Flower Spitter Diagram) Note: Minimum water level is 2 inches above the Water Pump.
7. Plug in.
8. Adjust the water flow by locating the Water Flow Adjustment Lever on the Water Pump side cover. Move the lever toward the + (plus)
sign to increase water flow or – (minus) sign to decrease water flow.
Water Pump
Tube
Corded Water Pump
Main Spitter Unit
Cord Clamp
PLANTER
(NOT INCLUDED)
Water Pump Tube
Corded Water Pump
with Water Flow
Adjustment Lever
Greta Flower Spitter
Figure 1 Figure 2
Figure 6
Figure 5
O W N E R S M A N U A L
Figure 3 Figure 4
Call us for assistance at:
+1 (619) 449-2392
or you can email us at:
customercare@berninifountains.com
Care Department
Monday - Friday
8:30am to 4:00pm PST
11:30am - 7:00pm EST
Figure 7
Need Help?
Our Customer
is available: