How To Deal With; When The Splice Loss Is Too High - UCL SWIFT SWIFT KR12 User Manual

HOW TO DEAL WITH THE SPLICING PROBLEMS
WHEN THE SPLICE LOSS
IS TOO HIGH
It may have been caused by dirt or dust
on the surface of fibers.
HOW TO
· Carefully clean the surface of the fibers.
· DO NOT clean the optical fiber after cutting to prevent
dust rom being gathered on optical fiber's cross section.
· DO NOT push in the optical fiber when putting is on V-Groove.
Optical fiber should be placed from top to bottom V-Groove.
The arrangement of the fibers can be interrupted
by the dirtin the V groove.
HOW TO
· Keep the V-groove clean at all times.
Bad electrodes
HOW TO
· Replace the electrodes.
The tips are bent or contaminated if they are worn out.
Improper arc discharge or arc discharge time.
HOW TO
· Check the set values of arc discharge amount and
arc discharge time and reset them, if necessary.
· The machine is delivered after being set to the most
optimized values from the factory.
Inappropriate splice mode
HOW TO
· Check if the proper splice mode for the fiber
has been selected.
��