Table of Contents
Advertisement
OPERATION
REMOVING
THE SPLICED FIBER
� Open the sleeve heater cover.
� Open the windshield cover.
� Hold the left-fiber holder and open the cover of
the right-fiber holder.
� Open the cover of the left-fiber holder.
� Hold the both sides of the spliced fiber and remove
the fiber from the Swift KR�� carefully not to break.
HEATING THE SLLEVE
� Move the center of sleeve to the splice point. Make sure the
strength member in the sleeve is downward.
� Put the sleeve to the center of the sleeve heater.
� Apply tension to the fiber downward so that the sleeve
heater cover is closed automatically.
� Press
to start sleeve heating.
HEAT
� The LED is turned off when sleeve heating is completed.
� Open the heater cover and remove the fiber. Do not touch
the sleeve and heater part immediately after heating.
� Check to ensure there is no bubble, fragments or dust
in the sleeve at all times.
��
Advertisement
Table of Contents
