ERROR MESSAGE
Mismatch Fiber Number
It is displayed when the number of
fibers is not consistent with opposite
side.
HOW TO
· Check all the fibers are placed on the
V-Groove.
· Make sure broken fibers.
· Check the splice mode is being used
properly.
Core Bubble Error
It is displayed when bubbles or dots exist
in the spliced part after completing the
splice.
HOW TO
· Check the condition of the cleaver.
· Clean the V-groove.
· Check the condition of the electrode.
Gap Limit Over
It is displayed when the measured gap
of the fiber is greater than the limit.
HOW TO
· Reset the fiber after checking the condition
of the cleaver.
��