Setup - Graco A Series Instructions And Parts List

NOTE: Reference numbers and letters in parentheses
in the text refer to the callouts in the figures and the
parts drawing.
See page 10 for accessories available from Graco. If
you supply your own accessories, be sure they are
adequately sized and pressure-rated to meet the
system's requirements.
Mounting the Pump on the Cart
CAUTION
To avoid tip-over, the cart must be on a flat and level
surface. Failure to follow this caution could result in
injury or equipment damage.
Refer to Fig. 1. The pail stop (15) and the clamps (13),
screws (14) and nuts (7) used to mount the pump are
shipped loose.
7
15
A
Fig. 1

Setup

1. Slide the pail stop (15) onto the uprights (A) at the
rear of the cart. Adjust the stop to the desired
position.
2. Set the pump (B) onto the cart so the baseplate of
the air motor rests on the pump supports (C).
Orient the pump fluid outlet (D) as shown in Fig. 1.
Two of the pump tie rods (E) will rest against the
pump supports (C). Hold the pump in this position
to keep it from tipping.
3. Fasten the clamps (13) around the two tie rods.
Insert the four screws (14) through the clamps
from the front, and secure from the rear using the
four nuts (7).
4. Install Wiper Plate 222–812 (carbon steel) or
222–909 (stainless steel) on the pump as ex-
plained in separate instruction manual 308–049.
5. Install Cart Accessory Kit 224–376 as explained in
separate manual 308–087 or 308–199.
14
C
13
E
D
B
0256