Ir-Transmitters; Connect A Camera; Computer; Bluetooth Sources - Bang & Olufsen Beovision Harmony Series User Manual

Table of Contents

1. Connect the cable to the appropriate socket on the camera.

2. Run the cable to a HDMI IN socket on the television screen.

3. Follow on-screen instructions to configure the source.

1. Using the appropriate type of cable, connect one end to the HDMI output socket on your computer,

and the other end to a HDMI IN (HDMI A-D) socket on the Soundcenter.

2. Follow on-screen instructions to configure the source.

You can use Bluetooth to stream from any music source or directly from your hand-held device. Connect

your device via Bluetooth to the television, refer to LG instructions.

Analogue audio source

You can connect one analogue audio source. To configure products connected to the Beovision Harmony,

see the chapter 'SET UP CONNECTED PRODUCTS'.

Disconnect all systems from the mains before you connect additional products.

1. Connect the cable to the appropriate socket on the product you wish to connect.

2. Run the cable to the LINE-IN socket on the television.

3. Reconnect the television and the connected products to the mains.

Different adaptors and possibly also cables are needed. Cables and adaptors are available from your Bang &

Olufsen retailer.

IR-transmitters

To operate non-Bang & Olufsen products with a Beoremote One, attach a Bang & Olufsen IR-transmitter on

your non-Bang & Olufsen product and then connect it to one of the sockets marked PUC on the connection

panel. Attach the transmitter near the IR-receiver on the connected product to ensure remote control

operation. Before attaching the transmitter permanently, check that you can operate the product menus on

the TV screen using BeoRemote One.

When you set up the transmitter to a selected PUC socket in the Sources menu found under Sound &

BeoLink... in the Bang & Olufsen TV App, the settings for the IR-transmitter can be made.

However, it is possible to perform a manual setup of the socket if alternative settings are required.

For an extra PUC cable, contact your Bang & Olufsen retailer.

Table of Contents