Set Up Connected Products; M A K E S E T T I N G S - Bang & Olufsen Beovision Harmony Series User Manual

M A K E S E T T I N G S

S E T U P C O N N E C T E D P R O D U C T S
If you connect additional video products to your sound center, then you can set up the products in the
Sources menu.
When the Beovision Harmony is switched on and you connect additional products to an HDMI IN socket, the
television will detect an unconfigured source. A message appears on the screen and you can follow on-
screen instructions to configure the source.
Registering a product connected to the television enables you to operate it with your Beoremote One.
However, for this, you must use one of the HDMI A-D sockets placed on the back of the Sound center in
combination with a PUC socket and an IR-transmitter.
Sources have default settings, for example, sound modes and speaker groups that suit most situations but
you can change these settings if you wish.
1. Press to bring up the Home menu.
2. Use the arrow buttons to select the Bang & Olufsen TV App and press the centre button.
3. Press or to select Sound & BeoLink... and press the centre button.
4. Press or to select Sources and press the button.
5. Press or to select a source and press the centre button.
6. Follow on-screen instructions.
You can give the source the name you want to appear in the source list if you select Name, press the centre
button and follow on-screen instructions.
*This change is also be reflected in your Beoremote One display.
In the Device setup menu you set up the connected product to a peripheral unit controller (PUC*) table and
a PUC socket and select if you want the product to switch to standby automatically.
*The peripheral unit controller enables you to operate a connected non-Bang & Olufsen product with the
Bang & Olufsen remote control. The peripheral unit controller built into your Beovision Harmony
"translates" signals from the remote control into signals understood by the connected product. For the
"translation" to take place correctly, the appropriate PUC table must be downloaded into your Beovision
Harmony.
You can set a speaker group to be activated when you select the source. For information about sound modes
and speaker groups, see the chapter 'SOUND SETTINGS'.