Network Requirements; Smarttrunk; 10Base-T Network - Cabletron Systems SmartSwitch 6000 Installation & User Manual

Before installing the SmartSwitch modules, review the requirements and specifications referred to
in this chapter concerning the following:
•

SmartTrunk

(Section
• 10BASE-T Twisted Pair Network
• 100BASE-TX Twisted Pair Network
• 1000BASE-SX, -LX Gigabit Ethernet
The network installation must meet the guidelines in this chapter and in the documents referenced
in this chapter to ensure satisfactory performance of the equipment. Failure to follow the
guidelines may produce poor network performance.
The Cabletron Systems Cabling Guide, referred to in the following sections, can be
NOTE
found on the Cabletron Systems World Wide Web site: http://www.cabletron.com/
2.1 SmartTrunk
To connect the SmartSwitch modules to a network so they can take advantage of the SmartTrunk
feature, there are certain rules concerning port connections and configurations that must be
followed for proper operation. For information on SmartTrunk configuration, refer to the
Cabletron Systems SmartTrunk User's Guide.
2.2

10BASE-T NETWORK

When connecting a 10BASE-T segment to any of the SmartSwitch ports, ensure that the network
meets the Ethernet network requirements of the IEEE 802.3 standard for 10BASE-T. Refer to the
Cabletron Systems Cabling Guide for details.
2.1)
(Section
(Section
(Section

Network Requirements

2.2)
2.3)
2.4)
Network Requirements
2
2-1