Husqvarna FS7000 D Operator's Manual page 42

To move the product with the engine on
1. Turn the engine start switch to ignition on position
(A).
2. Push the switch for cutting depth adjustment (B) up
until the cutting blade does not touch the ground.
3. Put the lever for speed control into the stop position.
4. If the product has a blade clutch, make sure that the
blade clutch is disengaged. The blade clutch is
disengaged when the symbol on the display is not in
a different color.
3
4
< 1200 RPM
180
150 210
110 250
˚F
STOP:
50 cm
5. If the product does not have a blade clutch, remove
the blade or move the gearbox lever to neutral
To remove the cutting blade on
position. Refer to
page 19 and To change gears on a 3-speed gearbox
model on page 20 .
WARNING: For products that do not
have a blade clutch, the cutting blade
starts to rotate when the engine starts.
Do not move the product to the side or
42
A
B
out of the work area if the cutting blade
rotates.
6. Start the product. Refer to
page 24 .
7. Push the lever for speed control forward for forward
saw movement, or rearward for reverse movement.
The more you push the lever for speed control, the
more the speed increases. Refer to
on page 45 .
WARNING: Do not open the
transmission bypass valve to neutral
position while the product is parked on a
slope. The product can move away from
you and cause injury to bystanders.
8. Adjust the resistance on the lever for speed control
with the nut on the side of the lever for speed
control.
To move the product up and down a ramp
WARNING: Be very careful when you move
the product up and down ramps with the
engine on. The product is heavy and there is
a risk of injury if the product falls or moves
too quickly.
WARNING: For ramps with a large angle,
always use a winch. Do not walk or stay
below the product.
To start the product on
Technical data
1223 - 002 - 09.07.2019