Husqvarna FS7000 D Operator's Manual page 34

5. Close the valve.
6. Fill a new engine oil filter with oil and install the
engine oil filter on the product.
7. Open an oil tank cap and fill the system with engine
Technical data on page 45 .
oil. Refer to
Note: There are 2 oil tank caps for engine oil.
To clean the radiator air filter
CAUTION: Do not operate the product
without the radiator air filter installed.
• Clean the radiator air filter with soap and water.
• Always replace a damaged radiator air filter.
34
To replace the hydraulic system filter
1. Remove the hydraulic system filter and discard it.
2. Fill a new hydraulic system filter with oil. Refer to
Technical data on page 45 for the correct type of
oil.
3. Lubricate the seal with some drops of oil.
4. Install the hydraulic system filter.
5. Make sure that the product is level.
6. Remove the plug from the inspection opening on the
hydraulic reservoir.
7. Remove the hydraulic reservoir cap and fill with new
oil to the correct oil level. Refer to
the hydraulic oil level on page 35 .
8. Install the hydraulic reservoir cap.
9. Install the plug in the inspection opening on the
hydraulic reservoir.
To do a check of
1223 - 002 - 09.07.2019