Husqvarna FS7000 D Operator's Manual page 33

3. Open the water valve.
4. Make sure that the jets of water go straight out from
the holes and onto each side of the cutting blade.
5. Make sure that there are no leakages in the water
pipes.
6. Replace the water pipes if they are damaged.
To drain the water separator for the fuel
filter
1. Put a container below the hose at the bottom of the
water separator for the fuel filter.
1223 - 002 - 09.07.2019
2. Turn the engine start switch to ignition on position
(A). Do not start the engine.
A
3. Let the fuel pump operate for approximately 15
seconds to increase the pressure in the fuel system.
4. Turn the engine start switch to the stop position (B).
5. Loosen the tap and drain the water from the water
separator into the container.
6. Tighten the tap.
7. Discard the water as chemical waste. Refer to
Disposal on page 44 .
To replace the engine oil and engine oil
filter
1. Put a cover on the battery to prevent oil spill on the
battery.
2. Remove the cap (A) from the oil drain hose for
engine oil.
B
3. Open the valve and bend the hose down to drain the
engine oil.
4. Remove the engine oil filter (B) and discard it.
B
A
33