Husqvarna FS7000 D Operator's Manual page 26

4. Push the engine speed button (A). The engine
symbol (C) shows that the speed adjustment knob
(B) adjusts the engine speed.
A
B
5. If the product has a blade clutch, do this procedure:
a) Make sure that the engine speed is not higher
than 1200 rpm.
2
1
0 4
14
b) Push the button adjacent to the blade clutch
symbol on the display. The symbol on the display
changes color to show that the drive on the
cutting blade is engaged.
3
4
< 1200 RPM
180
150 210
110 250
˚F
STOP:
50 cm
6. Turn the speed adjustment knob clockwise to
increase the engine speed to full throttle.
26
0
12
10 14 C
5.0
WORKING HOURS
8 18
V
CURRENT: STOP:
4.00˝ 1.50˝
RPM
3
< 1200 RPM
180
150 210
7. To set the blade lowering speed, turn the knob for
adjustment of the blade lowering speed. Turn
counterclockwise to increase the speed and
clockwise to decrease the speed.
4
180
150
110
˚F
8. Keep the adjustable pointer, the rear pointer and the
cutting blade on the line mark during the full
operation.
9. Push the switch for cutting depth adjustment down to
lower the cutting blade to the correct cutting depth.
Refer to
10. Push the lever for speed control forward slowly to
move the product forward.
11. Listen to the sound of the engine. Pull the lever for
speed control rearward to adapt the forward speed
to the sawing conditions.
Blade depth stop on page 24 .
CAUTION: If you lower the cutting blade
into a cut that is not fully completed,
align the cutting blade accurately with
the cut to prevent damage to the cutting
blade.
1223 - 002 - 09.07.2019