Husqvarna FS7000 D Operator's Manual page 29

To do before the maintenance
• Park the product on a level surface and stop the
engine. Push the machine stop button on the control
panel to prevent accidental start during
maintenance.
• Clean the area around the product from oil and dirt.
Remove unwanted objects.
• Put clear signs around the maintenance area to give
a warning to bystanders that maintenance work is in
progress.
Maintenance
Clean the product.
Do a check of the radiator coolant level.
Do a check of the engine oil level.
Do a check of the blade guard.
Examine all hoses and hose clamps. Look for damage
where the hoses rub against other hoses or parts of the
product.
Clean the outer air filter.
Do a check of the protective covers and blade guards.
Drain water from the gearbox.
Do a check of the water supply to the cutting blade.
Drain the water separator for the fuel filter.
Replace the engine oil and engine oil filter.
Clean the radiator air filter.
Do a check of the V-belts.
Lubricate the front wheels.
Replace the hydraulic system filter.
Lubricate the pivot bearings of the front axle.
Examine the wheels and wheel hubs for damage and
make sure that they are installed correctly.
Examine the air filter hose and hose clamps.
Do a check of the hydraulic oil level.
Lubricate the blade shaft.
Lubricate the pivot on the hydraulic cylinder.
Lubricate the rear axle bearing.
Replace the hydraulic oil.
Replace the oil in the gearbox.
1223 - 002 - 09.07.2019
• Keep fire extinguishers, medical supplies and an
emergency phone near.
Maintenance schedule
Note: If more than 1 time interval is identified in a table
row, the shortest time interval is for the first maintenance
only.
Safety devices on the product on page 12 for
* Refer to
instructions.
Daily and
after
50 h 100 h
transpor-
tation
X
X
X
*
X
X
*
X
X
X
X
X
X
X
X
X
250 h 500 h
X
X
X
X
X
X
X
X
X
X
Yearly
29