Webb WERR19SP Operator's Manual & Parts List page 6

INSTRUCTION MANUAL INSTRUCTION MANUAL
Position the handle assembly so you can fix
the handle to the machine using the two
fixing bolts (fig. 1)
Lift the handle to the correct height for the
operator and fit the two additional bolts to
secure the handle (fig. 2)
Fit the Operator Presence Cable, remove
the lever from its mounting by easing it from
the handle, attach the Z cable end to the
OPC lever. (fig. 3) Refit the OPC lever to
the handle.
Fit the Self Propelled drive cable, again
remove the lever from its mounting by
gently easing it from the handle, attach the
Z cable end to the Self Propelled drive lever
(fig. 4)
Ensure you have attached the correct cable
to the correct lever (fig. 5)
Fit the rope guide to the right hand side of
the handle (fig. 6)
Fit the cable router to the handle using the
securing bolt supplied. This should be fitted
to the inside of the handle (fig. 7)
6
Hold in the Operator control handle and
pull on the recoil starter rope so you can
attach it through the wire recoil rope guide.
(fig. 8)