Racking/Un-Racking The Inner Chassis - TransAct Epic 950 Tech Support Reference Manual

RACKING/UN-RACKING THE INNER CHASSIS

To Remove the Inner Chassis:
• Pull on the Ticket Cover to release the rear detents, pulling the
Inner Chassis towards you until its latches catch the forward
detent slots.
• Push the Inner Chassis back in slightly, pull on the Release Lever
and pull forward on the Inner Chassis to un-dock it from the Outer
Chassis.
To Return the Inner Chassis: (see warning before racking)
• Align the base of the Inner Chassis with the outer walls of the
Outer Chassis, seating it within side walls A and B as shown.
Make certain it's straight so the Inner Chassis doesn't damage
the flex cable.
• While pulling outwards on the Release Lever, slide the Inner
Chassis towards the rear of the Outer Chassis. Push the Inner
Chassis all the way to the back until it stops. When fully seated,
the front metal plate of the Inner Chassis and the front left edge
of the Outer Chassis are flush.
ATTENTION: Interconnect PC Board Assembly must be latched in position
shown. Check by trying to move the board by hand prior to racking.
MAKE SURE IT IS LATCHED
Ticket Cover
Release Lever
Inner Chassis
Side Walls A & B
6
Outer Chassis