Enrolling Fingerprints From Desktop Reader - CAMDEN CV-940 Series Installation Instructions Manual

8.3 Enrolling Fingerprints From Desktop Reader

Plug the Desktop Reader (CV-350ER) in the PC. If the
device is not installed automatically use the drivers
located on the CD provided with the Biometric reader. It
is installed in the same way as a USB Device. When the
desktop reader has been installed it will automatically
appear in the Software. (8.13)
1. Open the Users Window and create a new user. Click
on "New User", put a name and ID (card number). (8.7)
2. Go to the "Biometric" Tab.
3. Select the USB desktop Reader (with left click).
4. Place the finger on the CV-350ER, right click on the
fingertip and select enroll. (8.9)
5. The finger tip will turn red, with the percentage of
successful enrollment shown next to the fingertip.
(8.10)
6. Repeat point 5 for each finger that should be enrolled.
7. Click on "Save New" and the fingerprint will be sent
automatically to all Biometric Readers where that user
8.7
8.9
8.12
has access, i.e. to all the readers according to the
Access Level assigned to that user.
If the reader is off line, the fingers will be sent once the
connection is established between CAMS server and the
reader. No need for additional enrollment or actions.
The fingerprints will be sent as soon as communication
is established.
Example: If the user has "Unlimited" Access level then
the fingerprints will be sent to all readers, if the user has
Access level only for Reader 1 and Reader 3 then the
fingerprints will be sent only to those two readers.
Note: To check if all the fingerprints are sent to the
reader, right click on the reader and select "Memory
Status". (8.11) In the event window a line will appear
indicating the number of fingerprints stored in the
reader. (8.12)
If more fingerprints are added for one user, all fingerprints
will send the same Wiegand Code to the controller, the
one written in the field User ID(card Number).
8.11
8.10
Page 9 of 19
CV-940 Series
8.13