Table of Contents
Advertisement
9.4 Calibrate Sensor
• Right-click on the reader and select Calibrate
• See the events panel to check the calibration flow
It is recommended to do sensor calibration once
after reader is mounted. Clean the fingerprint sensor
before calibration.
9.5 Enrolling Fingerprints From a Reader
1. Open the Users Window and create a new user.
Click on "New User", put a name and ID (card
number). (10.1)
2. Go to the "Biometric" Tab
3. Select the reader(with left click) from which the
enrollment will be done. (10.2)
4. Right click on the fingertip and select enroll. (10.3)
5. In the next 25 sec. present the finger on the selected
reader and the finger tip will turn red, with the
percentage of successful enrollment shown next to
the fingertip. (10.4). In these 25 sec. the reader will
continuously blink in orange.
6. Repeat point 4 & 5 for each finger that should be
enrolled.
10.1
10.4
10.6
7. Click on "Save New" and the fingerprint will be sent
automatically to all Biometric Readers where that user
has access, i.e. to all the readers according to the
Access Level assign to that user.
Example: If the user has "Unlimited" Access level then
the fingerprints will be sent to all readers, if the user has
Access level only for Reader 1 and Reader 3 then the
fingerprints will be sent only to those two readers.
Note: To check if all the fingerprints are sent to the
reader, right click on the reader and select "Memory
Status". (10.5). In the event window a line will appear
indicating the number of fingerprints stored in the
reader. (10.6)
If more fingerprints are added for one user, all fingerprints
will send the same Wiegand Code to the controller, the
one written in the field User ID(card Number).
10.2
Page 14 of 19
CV-940 Series
Fig. 9.4
10.3
10.5
Advertisement
Table of Contents
