Subscribe to Our Youtube Channel
Related Manuals for Amantii DESIGNER Series
Summary of Contents for Amantii DESIGNER Series
- Page 1 INSTALLATION AND OPERATING INSTRUCTIONS FOR WALL MOUNT UNITS WM-38, WM-58, WM-95 DESIGNER SERIES WM-62, WM102 INSTALLER: LEAVE THIS MANUAL WITH THE APPLIANCE.CONSUMER: RETAIN THIS MANUAL FOR FUTURE REFERENCE.
-
Page 2: Reference Guide
REFERENCE GUIDE Prior to installation, please ensure: Your socket-outlet is enough for your fireplace against both voltage and capacity.; The light bulbs in your firebox are in good condition. For checking this, please follow the instructions for replacing the light bulbs on section MAINTENANCE. The heater on your fireplace may emit a slight, harmless odor when first used. -
Page 3: Important Instructions
IMPORTANT INSTRUCTIONS WARNING You should read and always follow the important instructions below to reduce the risk of fire, electric shock, and injury to persons. 1. Read all instructions before using this fireplace. 2. This fireplace is hot when in use. To avoid burns, do not let bare skin touch hot surfaces, such as surfaces near the heater outlet or light bulbs. -
Page 4: Installation
INSTALLATION This section provides step-by-step instructions for installation of your fireplace. WARNING The socket must be 15A/125V. 1. This fireplace is designed to be able to hang on solid walls only. Select a suitable location, which is not susceptible to moisture, safe, dust free, away from high traffic and away from things may catch fire or block openings such as drapes, furniture, etc. - Page 5 CAUTION The fireplace needs to be installed in a dry, safe and dustless place. 15A/125V 4. If there's no socket near the desired location, install a new one nearby. WARNING Do not attempt to wire you own new sockets or circuits. To reduce the risk of fire, electric shock or injury to persons, always use a licensed electrician.
-
Page 6: Remote Operation
OPERATION This section will explain the function of each convenient control. NOTE The heater may emit a slight, harmless odor when first used. This odor is a normal condition caused by initial heating of internal heater parts and will not occur again. Control Panel Operation A. - Page 7 <FLAME> stop at the current location, adjusted speed the process of blinking display (as dimmer lights flicker frequency ), do not adjust flame speed then the is brighten up. 4. Press <HEAT> button, process of operations in accordance with LOW-HIGH-OFF-LOW ..status, between the cycle of low-power to high-power and then off.
-
Page 8: Maintenance
MAINTENANCE WARNING Disconnect power before attempting any maintenance or cleaning to reduce the risk of fire, electric shock to persons or damage. Light Bulb Replacement Light bulbs need to be replaced when you notice a dark section of the flame or when the clarity and detail of the log exterior disappears. - Page 9 Correct Disposal of this product This marking indicates that this product should not be disposed with other household wastes throughout the EU. To prevent possible harm to the environment or human health from uncontrolled waste disposal, recycle it responsibly to promote the sustainable reuse of material resources.
- Page 10 Date of Purchase: Dealer Information:...
Need help?
Do you have a question about the DESIGNER Series and is the answer not in the manual?
Questions and answers