Advertisement
Quick Links
Advertisement
Related Manuals for BROSA Leonie Desk
Summary of Contents for BROSA Leonie Desk
- Page 1 Leonie Desk A S S E M B LY G U I D E...
- Page 2 F O R Y O U R S A F E T Y Lift, don’t drag. This protects Check the assembly guide your floor and product. for required components. Assembly requires 2 people. Assembling this product on It's always easier with a a soft surface protects its friend.
- Page 3 Components Before you get started, check you have all of the pieces below. If anything’s missing, we’ll sort it out right away. Simply visit: www.brosa.com.au/pages/product-return-and-parts-request ③ Left Leg Frame x 1 ④ Brace x 1 ② Right Leg Frame x 1 ①...
- Page 4 Step 1 ② ③ Fit both leg frames into the holes on the bottom of the table top ①. Make sure the hole on the side rail is positioned at the rear side as shown in the diagram below. ③ ②...
- Page 5 Step 2 Fit a washer to a small bolt and then insert the bolt into a hole on the leg frame. Tighten the bolt with your hand and leave it loosely attached. Repeat this for the remaining holes on the leg frames.
- Page 6 Step 3 ④ Align the brace with the holes at the rear side of the leg frames and the bottom of the table top. ④...
- Page 7 Step 4 Insert a big bolt into the hole on the side rail and make it grab the threads in the tubular rail. Leave the bolt loosely attached. Repeat this for the other side.
- Page 8 Step 5 Fit the washer to the small bolt and then insert the bolt into the hole behind the drawer. Tighten the bolt with your hand and leave it loosely attached.
- Page 9 Step 6 Once the structure is built up, tighten all bolts with the Allen key D.
- Page 10 Step 7 Flip the completed piece of furniture and place it upright on a level surface. Enjoy your new Leonie Desk!
-
Page 11: Troubleshooting
Troubleshooting 1. Follow the steps below to detach the drawer if needed. Step 1 Pull the drawer until the levers of the drawer slides come out as shown in the zoomed-in diagram below. Step 2 Press down on the lever on one side and up on the opposite side to disengage the mechanism. - Page 12 2. Follow the step below to attach your drawer again. Step 1 Line up the slides and push until you hear the “click” indicating that the slides have re-engaged.
- Page 13 With that in mind, the following tips can help prolong the life of your Brosa veneer furniture to help them look beautiful for years to come. Assembly 1. Assemble furniture using our Assembly Guides. You can find them at support.brosa.com...
- Page 14 3. Do not use any abrasive cleaner or harsh detergent as this can damage the surface of the furniture. 4. Avoid using spray polishes as they contain silicones which may spoil the furniture’s surface. 5. Make sure all surfaces are protected from heat and liquids by mats and coasters.
Need help?
Do you have a question about the Leonie Desk and is the answer not in the manual?
Questions and answers