Txp-Wta Legacy Mode - Macurco TracXP TXP-WTA Instruction Manual

TXP-WTA_Instruction_Manual_(Rev1.3)

11 TXP-WTA Legacy Mode

TXP-WCR Controllers are not compatible with TXP-WTA Transmitters in legacy mode.
When using a TXP-WTA with other TracXP products–such as the TXP-C20, TXP-C40, and TXP-C16 or other legacy type
controllers–it is necessary to operate wirelessly in Legacy Mode.
To Enter Legacy Mode:
1. Swipe the EDIT key to enter the Main Menu.
2. Select "Device Setup" with the Up & Down Arrows the swipe EDIT.
3. Select 'RF Link Setup' and swipe EDIT.
4. Scroll to the bottom of page 2 and select 'RF Link' then swipe EDIT.
5. Enter the key sequence of four up arrows and when you see the ****Warning****, swipe EDIT.
6. Your WTA is now in Legacy Mode and now you can scroll to the top of page 1 and select the Hop Channel
and System ID to match the controller.
All other transmitter settings function as discussed in the TXP-WTA Sensor Transmitter manual.
REV – 1.3 [34-2900-0207-4 ] 48 | P a g e