Table of Contents
Advertisement
TXP-WTA_Instruction_Manual_(Rev1.3)
8 Channel Setup Menus
The Channel 1 / 2 Menus accessed from the Main Menu are shown in Figure 7 1.
Figure 8-1 – Channel Setup Menus
8.1 Channel Enable / Inactive
Use the top menu in the group to make this channel either "ENABLED" or "INACTIVE".
NOTE: Channels should only be activated if a sensor is connected (see Section 5.5).
8.2 Configure Readout
The Configure Readout group shown in Figure 7 2 has 2 pages of menus for controlling how sensor signals are
displayed and how alarms are activated for this channel.
NOTE: Backup Config. and Load Defaults are used if there is an issue with the wireless system. These features allow
the user to back-up the Smart Sensor or restore the smart sensor element to factory defaults (see Section 7.2.9).
Figure 7-2 – Configure Readout Setup Menus
REV – 1.3
[34-2900-0207-4 ]
30 |
P a g e
Advertisement
Table of Contents
