Table of Contents
Advertisement
TXP-WTA_Instruction_Manual_(Rev1.3)
The 2.4 GHz radio module also mounts to the back of the Display transmitter as shown in Figure 3 3. Its u.FL RF
connector attaches to the coax pigtail of the antenna fitting required for 2.4 GHz models.
A slender 5 conductor cable connects between the Display / Radio Board and the Battery Board bolted to the
bottom of the enclosure.
NOTE: The Display / Radio Board accepts either the 900 MHz or 2.4 GHz radio module. A Shield Board is not shown
but, must be removed to access the radio modules and RF connectors.
Figure 4-3 – Display / Radio Board
REV – 1.3
[34-2900-0207-4 ]
17 |
P a g e
Advertisement
Table of Contents
