Macurco TracXP TXP-WTA Instruction Manual page 43

TXP-WTA_Instruction_Manual_(Rev1.3)
The TXP-WTA Sensor Transmitter displays one of three RANGE ICONS (
achieving the Server In-Range status necessary to broadcast its data.
is desired since it indicates every attempt to broadcast since power up has been successful.
•
• indicates, during the most recent attempt, the Server could not be found.
• indicates the most recent attempt was successful, however, an earlier attempt was unsuccessful.
If the wireless controller is experiencing comm errors, there are two probable causes:
1. The TXP-WTA Sensor Transmitter is not achieving "Server In-Range" status and therefore not broadcasting.
2. The TXP-WTA Sensor Transmitter broadcasts but the data is either not received by the controller or the TXP-
WTA Sensor Transmitter is receiving the acknowledgment of the transmission from the controller.
TXP-WTA Sensor Transmitter range icons help isolate #1 or #2 since if the desired
problem. However, if intermittent controller comm errors occur, and
Transmitter is not reliably achieving a Server In-Range status.
REV – 1.3
, ,
is displayed it is likely the TXP-WTA Sensor
[34-2900-0207-4 ]
) to indicate if its radio has been
is displayed, #2 must be the
43 | P a g e