Operating Instructions; Using The Magnetic Keypad; Cycling Sensor Transmitter Power On / Off - Macurco TracXP TXP-WTA Instruction Manual

Wireless sensor transmitter

Table of Contents

TXP-WTA_Instruction_Manual_(Rev1.3)

6 Operating Instructions

Each TXP-WTA Sensor Transmitter is supplied with an 83-700N-0000-00 (AL and SS) or 83-700M-0000-00 (Poly)

magnetic wand for non-intrusive magnetic keypad operation.

Keys are identified as UP, DOWN, NEXT and EDIT and function similar to touch keys except a "swiping" motion of the

magnet is used instead of pressing a key.

In this manual, a "swipe" means:

1. Place the magnet against the enclosure's glass cover above the key and pull it away in the same motion.

2. Each "swipe" equals one press of the key.

NOTE: In the following procedure "Swiping" the magnet is a Momentary hold. It's like using the magnet to "Press &

Release" a button. Be careful not to "swipe" too close to one of the other keys and activate it by mistake.

To modify a menu item:

1. Using the UP and DOWN keys to move the selector arrow on the left side of the display next to the item to

be edited.

2. Swipe the EDIT key to display the flashing cursor below the letter/number to be edited.

3. Swipe UP/DOWN to change that character to the desired letter/number.

4. Swipe NEXT to move the cursor to the next letter/number to be edited.

5. After you are finished entering all the letter/numbers needed, swipe EDIT to save the changes and exit the

edit text mode.

NOTE: There are two different magnetic wands available (83-700N-0000-00) and (83-700M-0000-00). Although they

will both function on the TracXP units, it is best to use the same magnet type that was received with your product.

6.2

It is not necessary to remove the non-intrusive enclosure's cover to cycle power ON or OFF. If the LCD readout is

blank the TXP-WTA Sensor Transmitter is OFF.

POWER ON – Apply Power

1. Hold the magnet over the UP key in the upper left front panel for a few seconds

2. When the LCD shows Release Key, pull the magnet away and power will remain ON.

POWER OFF – Disengage Power

1. Hold the magnet over the NEXT key in the upper right front panel.

2. When the LCD shows EDIT to Accept, swipe the magnet over the EDIT key and power will turn OFF.

REV – 1.3

Figure 6-1 – Magnetic Wand

[34-2900-0207-4 ]

22 |

P a g e

Table of Contents