Gigaset V300AM Setting Up page 30

V300AM / USA EN / A31008-xxxxx-xxxx-x-6019 / registr_sett.fm / 3.1.08
Using several handsets
Activating the room monitor and
entering the number to be called
¢ ¢
v í
Room Monitor
¤
Change multiple line input:
Room M.:
Select to activate.
On
Call to:
Press the display key
tination number.
External number: select number from
the directory or enter directly. Only the
last 4 digits are displayed.
Internal number: delete any stored
external number.
set or Call All, if all registered handsets
are to be called)
Store number with
Level:
Set noise level sensitivity
¤
Save changes (page 49).
The function is now activated. With
, you can move directly to settings.
Options
Changing previously set external
destination number
¢ ¢
v í
Room Monitor
s
Scroll to the
Press the display key.
§Edit§
X
Delete existing number.
¤
Enter number as described in "Activat-
ing the room monitor and entering the
number to be called" (page 30).
¤
Save changes (page 49).
30
and enter des-
§Edit§
s (select hand-
§INT§
.
§OK§
.
§Save§
(Low or High).
line.
Call to:
Changing previously set internal
destination number
¢ ¢
v í
Room Monitor
s
Scroll to the
Press the display key.
§Edit§
Press the display key to con-
§Yes§
firm the prompt.
¤
Enter number as described in "Activat-
ing the room monitor and entering the
number to be called" (page 30).
¤
Save changes (page 49).
Deactivating the room monitor
remotely
Important: The destination phone must
support touch tone dialing and the room
monitor should be set for an external des-
tination number.
¤
Take the call from the room monitor
and press keys 9 ;.
The room monitor function will deactivate
after the call ends. There will be no further
room monitor calls. But the other room
monitor settings on the handset (such as
no ringtone) will remain activated until
you press the display key
handset.
To reactivate the room function with the
same phone number:
¤
Turn on the activation again and save
(page 30) with
§Save§
line.
Call to:
on the
§OFF§
.