Operating You Wine Cabinet And Setting The Temperature - Caple Wi6117 Instruction Manual

Operating your wine cabinet and setting the temperature
Please use the cabinet within a ambient temperature range of 5-32 ºC, if the ambient
temperature is higher or lower than this, it will cause the temperature to fluctuate in the
cabinet, which may prevent it from reaching 3-18 ºC.
Control panel
•
"Run"
The indicator light illuminates to signify the cooling mode is currently in operation.
•
"Light " Button
Turns the inner light on/off.
•
"Power" Button
Switches the appliance on/off
•
"Up" Button
Used to raise (warm) the temperature in increments of 1ºC.
•
"Down" Button
Used to lower (cool) the temperature in increments of 1ºC.
Setting the temperature controls
•
To set the temperature connect the power cord to a properly grounded outlet. In the event of
power interruption, the previous temperature setting is automatically erased and it will default to a
preset temperature setting of 12°C.
•
Set the desired cooling temperature by pressing the buttons adjacent to the "UP/DOWN"
indicators. Each depression of the buttons will scroll through the available temperature setting in
increments of 1 degree.
•
The temperature setting can be adjusted from 3°C -18°C
•
To view the actual temperature at anytime press and hold the temperature adjustment button (up
or down) for approximately 5 seconds, the actual temperature will temporarily flash in the LED
display for 5 seconds. After this it will revert back to the set temperature.
Flashing LED = Cabinet temperature
Steady LED = Set temperature
Note
•
If the unit is unplugged, power lost, or turned off, you must wait 3 to 5 minutes before restarting
the unit. If you attempt to restart before this time delay, the wine cabinet will not start.
• When you use the wine cabinet for the first time or restart the cabinet after having been shut off
for a long time, there could be a few degrees variance between the temperature you select and
the one indicated on the LED readout. This is normal and it is due to the length of the activation
time. Once the wine cabinet is running for a few hours everything will be back to normal.
(press and hold this buttons for approximately 3 seconds).
5