Operating You Wine Cabinet And Setting The Temperature - Caple Wi6127 Instruction Manual

Slot-in wine cabinet
Hide thumbs Also See for Wi6127:
Table of Contents

Advertisement

Operating your wine cabinet and setting the temperature
Please use the cabinet within a ambient temperature of 5-32°C, if the ambient temperature is
higher or lower than this, it will cause a temperature fluctuation in the cabinet and may
prevent it reaching 5-18 °C.
Control Panel
"Light" Button
Switches the interior light ON/OFF
"Run"
The indicator light illuminates to signify the cooling mode is currently in operation.
"Power" Button
Turns this appliance turn on/off. (press and hold this buttons for approximately 3 seconds).
"Set Upper" Button
To set the temperature in the upper compartment: The temperature setting can be adjusted from
5°C to 10°C. When pressing this button, the system will enter the set up mode for the upper
compartment automatically. The LED will flashing and display the set temperature.
Press the button once and the temperature will decrease by 1 degree. When exceeding the
minimum value that can be established, it will jump to the highest adjustable temperature value
automatically. After 5 seconds the LED figure will stop flashing.
"Set Lower" Button
Used to set the temperature in lower compartment: The temperature setting can be adjusted
from 10C to 18C When pressing this button, the system will enter the set up mode for the upper
compartment automatically. Setting details are the same as above.
"Upper" Window
Displays the temperature in the upper compartment.
"Lower" Window
Displays the temperature in the lower compartment.
After the unit is unplugged, the system will return to the factory set temperature. The
temperatures are shown below:
Upper compartment: 6°C
Lower compartment: 12°C
To view the actual temperature at anytime press and hold the temperature adjustment button (Set
Upper or Set Lower) for approximately 5 seconds, the actual temperature will temporarily flash in
the LED display for 5 Seconds. After this it will revert back to the set temperature.
Flashing LED = Cabinet Temperature
Steady LED = Set Temperature
5

Advertisement

Table of Contents
loading

Table of Contents