Panasonic KX-TG6711BX Operating Instructions Manual page 46

Useful Information
Liquid damage
Problem
Liquid or other form of
moisture has entered the
handset/base unit.
Caution:
R To avoid permanent damage, do not use a microwave oven to speed up the drying process.
Registering a handset to the base unit
1
Handset:
#130
2
Base unit:
Proceed with the operation for your model.
n KX-TG6711 series: page 3
Press and hold M
n KX-TG6721 series: page 3
Press and hold M
R If all registered handsets start ringing, press M
(KX-TG6712/KX-TG6722)
R The next step must be completed within 90 seconds.
3
Handset:
a Wait until "Base PIN" is displayed. a Enter the base unit PIN (default: "0000").
a
R If you forget your PIN, contact an authorised service centre.
R When the handset has been registered successfully,
Note:
R While registering, "Base in registering" is displayed on all registered handsets.
(KX-TG6712/KX-TG6722)
Deregistering a handset
1
#131
R All handsets registered to the base unit are displayed.
2
MbN: Select the handset you want to cancel. a
3
MbN: "Yes" a
R A confirmation tone sounds.
R The handset does not beep when cancelling its own registration.
4
M N
46
TG67xxBX_UE(en)_0125_ver101.pdf 46
Cause/solution
R Disconnect the AC adaptor and telephone line cord from the
base unit. Remove the batteries from the handset and leave to
dry for at least 3 days. After the handset/base unit are
completely dry, reconnect the AC adaptor and telephone line
cord. Insert the batteries and charge fully before use. If the unit
does not work properly, contact an authorised service centre.
N for about 5 seconds. (No registration tone)
N for about 5 seconds, until the registration tone sounds.
N again to stop, then repeat this step.
is displayed.
2017/01/25 11:28:23