Table of Contents
Advertisement
1
#255
2
Enter an area code (5 digits max.). a
a M
N
Setting call restriction
You can restrict selected handsets from
dialling certain numbers. You can assign up to
6 phone numbers to be restricted, and select
which handsets are to be restricted. Storing
area codes here prevents the restricted
handsets from dialling any phone number in
that area code.
1
#256
2
Enter the base unit PIN (default: "0000").
R If you forget your PIN, contact an
authorised service centre.
3
Select the handsets to be restricted by
pressing 1 to 2.
R All handsets registered to the base unit
are displayed.
R " " is displayed next to the selected
handset numbers.
R To cancel a selected handset, press
the same dial key again. " "
disappears.
4
5
Select a memory location by pressing 1
to 6. a
6
Enter the phone number or area code to
be restricted (8 digits max.). a
M
N
R To erase a restricted number, press
.
Changing the base unit PIN
(Personal Identification Number)
Important:
R If you change the PIN, please make note of
your new PIN. The unit will not reveal the
PIN to you. If you forget your PIN, contact
an authorised service centre.
1
#132
TG67xxBX_UE(en)_0125_ver101.pdf 29
2
Enter the current 4-digit base unit PIN
(default: "0000").
3
Enter the new 4-digit base unit PIN. a
a M
Increasing the range of the base
unit
You can increase the signal range of the base
unit by using a DECT repeater. Please use
only the Panasonic DECT repeater noted on
page 4. Contact your Panasonic dealer for
details.
Important:
R Before registering the repeater to this base
unit, you must turn the repeater mode on.
R Do not use more than one repeater at a
time.
Setting the repeater mode
1
#138
2
MbN: Select the desired setting. a
a M
N
Note:
R After turning the repeater mode on or off,
is displayed on the handset
momentarily. This is normal and the
handset can be used once
a
Registering the DECT repeater
(KX-A405) to the base unit
Note:
R Please use a repeater that has not yet been
registered to another unit. If the repeater is
registered to another unit, deregister it first,
referring to the Installation Guide for the
DECT repeater.
1
Base unit:
Proceed with the operation for your model.
n KX-TG6711 series: page 3
Press and hold M
seconds. (No registration tone)
Programming
N
is displayed.
N for about 5
29
2017/01/25 11:28:22
Advertisement
Table of Contents
