Table of Contents
Advertisement
(also refer to 8.1. initial setting)
serial port setup
Port
Bit per second
Data bits
Parity
Stop bit
Flow control
serial port setup
check next check boxies
ASCII Sending - Sending line ends with line feeds
ASCII Receiving - Append line feeds to incoming
line ends
7. Supply a voltage to the TEL jack from the AC adaptor (KX-TCA1) / via power supply Adaptor
(PSZZ1TDA0142)
8. Connect the frequency counter probes the P.C.B. the test pads (SYRI, GND).
9.2.3. Adjustment (RF Clock)
Description of RF Calibration Process
Text following "Command:" is the input command for the terminal connected to the CS.
Text following "Response:" is the terminal display response data.
Confirm the response before proceeding to the next step.If no response is set. shot off power
and repeat from the beginning.
PDF created with pdfFactory Pro trial version
COM1
19200
8
None
1
Xon/Xoff
Warp line that exceed terminal width
23
www.pdffactory.com
Advertisement
Table of Contents
