Table of Contents
Advertisement
2. Remove 2 antennas from CN103 and CN104 (Refer to 6.
DISASSEMBLY INSTRUCTION 2.)
3. Remove the P.C.B from upper cabinet (Refer to 6. DISASSEMBLY
INSTRUCTION 3.)
4. Solder cable to ANT1(CN103) (Refer to figure)
5. CMD60 set up.
TEST MODE
CONFIG MENU
SCRAMBLE
ANTENNA
PMID
TRAFFIC SLOT
TRAFFIC CARRIER
6. Set Dip switch pin 1 , pin 5 ,and pin 6 from OFF to ON.
7. Connect power supply cable and AC adaptor.
9.1.2.2. RF test
1. Set the CMD60 to MANUAL TEST.
2. Set the CMD60 TRAFFIC CARRIER to 5.
3. Press ACCEPT RFPI and SETUP CONNECT on the CMD60.
4. Check Power (NTP) : must be +20 to +25dBm
5. Press MODULATION.
6. Set Data Type to "FIG 31".
7. Check the Frequency Offset : must be 0±50kHz.
8. Check the Deviation ( Max. ±B Field ) with Data Type "FIG.31" :
PDF created with pdfFactory Pro trial version
FP
SIGN. PARAM
OFF
1 ( at CN103 )
* If you solder cable to ANT2 ( CN104 ) , you should select
the CMD60.
0000
0
5
17
www.pdffactory.com
Advertisement
Table of Contents
