Advertisement
Connecting Network Cables
•Connecting Network Cables
The ST-POEAF-8/16-RM has 16 10/100Mbps Ethernet ports, with 8 PoE-enabled ports. Each
port incorporates 10/100Mbps support via UTP Cat5/5e cables.
The 8 PoE ports will automatically activate when a compatible device is identified.
Legacy devices that are not compatible will not be supplied power. This feature allows users to
freely and safely mix legacy and Power over Ethernet compatible devices on a single network.
This Switch supports 10Mbps Ethernet or 100Mbps Fast Ethernet and runs both in half and full
duplex mode using two pairs of Category 5 or 5e cable.
All ports are Auto-MDI type port. The switch can auto negotiate to MDII or MDI-X type, so you can
connect RJ-45 cable regardless of whether it is a standard or crossover cable.
Description
•Front Panel:
This is the front panel of the ST-POEAF-8/16-RM, showing the 16 RJ-45 ports and LED
display.
• Port 1X to 8X :
Standard 10/100Mbps Ethernet port. The Switch supports 10Mbps Ethernet or 100Mbps Fast
Ethernet and runs both in half and full duplex mode using two pairs of Category 5 or 5e cable.
All are 10/100Mbps switch ports as well as 802.3 af PoE enabled ports.
All PoE ports will automatically activate when a compatible terminal is identified. The ST-
POEAF-8/16-RM will supply power through the Ethernet port to the connected PoE device
(PD). It also supports legacy devices that are not compatible. In this case the PoE port will not
supply power to those devices. This feature allows users to freely and safely mix legacy and
Power over Ethernet compatible devices on the same network.
These RJ-45 ports are Auto-MDI type port. This switch can auto negotiate to MDII or MDI-X
type, so you can connect the RJ-45 cable regardless of whether it is a standard or crossover
cable.
Description
•AC power input and power switch:
The AC power input and power switch are located on the rear panel right side of the
ST-POEAF-8/16-RM. Press the power switch to turn the unit on or off.
4
Advertisement
