Advertisement
•FCC Warning:
This device has been tested and found to comply with the regulations for Class B digital equipment,
pursuant to Part 15 of FCC Rules. These limits are designed to against harmful interference when
the equipment is operated in a commercial environment. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and used in accordance with users guide, may
cause harmful interference to radio communications. Operation of this device in a residential area is
likely to cause harmful interference, in which case the user will be required to correct the
interference at his/her own expense.
•CE Mark Warning:
This is a Class B product. In a domestic environment, this product may cause radio interference,
in which case the user may be required to take adequate measures.
•UL Warning:
If installed in a closed or multi-unit rack assembly, the operating ambient temperature of the rack
environment may be greater than room ambient. Therefore, consideration should be given to
installing the equipment in an environment compatible with manufacturer's maximum rated
ambient temperature
Reduced Air flow - Installation of equipment in a rack should be such that the amount of air flow
required for safe operation of the equipment is not compromised.
Uneven Mounting- Installation of equipment in a rack should be even so as to avoid potentially
hazardous conditions
Introduction
The ST-POEAF-8/16-RM combines a small-high efficiency 16-port 10/100Mbps Ethernet switch with
a standard 802.3 af 8-port Power over Ethernet (PoE) capability. This switch incorporates an
external 48VDC power adaptor. Each of the PoE Ethernet ports can provide 15.4 Watts of power as
well as 10/100M data transmission over an Inter- connecting Ethernet interface such as Cat 5/ 5e /6
cables.
The ST-POEAF-8/16-RM is a Power Source Equipment (PSE) and fully compatible with Powered
Devices (PD) that comply with the IEEE 802.3 af PoE standard. The ST-POEAF-8/16-RM enables
users to attach IEEE802.3 af compliant devices such as wireless Access Points (APS), VOIP phone,
IP camera, printer and Network Attached Storage (NAS) directly to the ST-POEAF-8/16-RM without
requiring additional power on the network. The unit was designed with home and small business
users in mind and is ideal for installations where AC power is not available or is not cost-effective.
No configuration is required and installation is quick and easy. Support for Auto – MDI / MDI-X on all
of the ports eliminates the need for crossover connection to another switch or HUB. Auto -
Negotiation on each port senses the link speed of a network device (either 10 or 100) and
intelligently adjusts for compatibility and optimal performance.
* This device is designed for indoor use. Do not use outdoors.
* Installation manual and 48VDC power adaptor included.
2
Advertisement
