Other Programming; Registering A Unit - Panasonic KX-TGF675 Operating Instructions Manual

Programming
Answering the baby monitor
n When monitoring with a unit:
Handset: Press M
Base unit: Press MZN to answer a call.
If you want to respond from the monitoring
unit, press MMUTEN.
R The monitoring unit will answer calls
automatically when the auto intercom
feature is set to "On" (page 32).
Note:
R If you receive an outside call when
communicating with the monitored
handset, the interrupt tone sounds.
– To answer the call with the handset,
press MOFFN, then press M
– To answer the call with the base unit,
press MZN 3 times.
*1 If MMUTEN is pressed, press MZN 2
times.
n When monitoring from outside:
Answer the call.
If you want to respond from your monitoring
phone, press #1 using tone dialing.
You can turn off the baby monitor feature
by pressing #0.
Note:
R The unit disconnects the call
automatically after 2 minutes.

Other programming

Changing the handset name
The default handset name is "Handset 1" to
"Handset 6". You can customize the name
of each handset ("Bob", "Kitchen", etc.). This is
useful when you make intercom calls between
handsets. To display the handset name in
standby mode, turn on the handset name
display feature (page 58).
Handset
1
MMENUN#104
2
Enter the desired name (10 characters
max.). a MSAVEN a MOFFN
For assistance, please visit http://shop.panasonic.com/support
58
N to answer a call.
N.
*1
Displaying the handset name
You can select whether or not the handset
name is displayed in standby mode. The
default setting is "Off".
Handset
1
MMENUN#105
2
MbN: Select the desired setting. a
MSAVEN a MOFFN

Registering a unit

Operating additional units
Additional handsets
Up to 6 handsets can be registered to the
base unit.
Important:
R See page 5 for information on the available
model.
Registering a handset to the
base unit
The supplied handset and base unit are
pre-registered. If for some reason the handset
is not registered to the base unit, re-register
the handset.
1
Handset:
MMENUN#130
MbN: "Panasonic DECT" a
MSELECTN
2
Base unit:
Press and hold MLOCATORN for about 5
seconds.
R If all registered handsets start ringing,
press MLOCATORN again to stop, then
repeat this step.
3
Handset:
Press MOKN, then wait until a long beep
sounds.