Using The Remote - InFocus INF6501C User Manual

Using the Remote

The remote uses two (2) AAA batteries (not included). Install the batteries by removing the cover from the remote's back, aligning
the + and – ends of the batteries, sliding them in place and replacing the cover.
To operate, point the remote at the monitor sensor at the bottom right-hand corner of the monitor. The range of optimum operation
is about 26' (8m) and within a horizontal and vertical angle of 30 degrees.
CAUTION:
• When disposing of the batteries, be sure to do so in an environmentally proper manner.
• If the remote control gets wet, wipe it dry immediately.
• Avoid excessive heat and humidity.
• Ensure the batteries' polarity (+/-) is properly aligned.
• Do not mix new and old batteries or different types of batteries together.
• Replace the batteries as soon as they run out.
• Remove batteries from the remote control when storing or not in use for a prolonged period.
INF6501c/INF6501w User Guide
30˚ 30˚
Page 13