Use The Remote - InFocus INF6501a Hardware Manual

Use the Remote

The remote uses a single DC 3V CR2025 battery (not included). Install the battery by removing the battery holder, placing the battery
in the battery holder with the + end up, and sliding the battery holder back into place.
To operate, point the remote at the monitor sensor at the bottom right-hand corner of the monitor. The range of optimum operation
is about 19.5' (6m) and within a horizontal and vertical angle of 30 degrees.
CAUTION:
• When disposing of batteries, be sure to do so in an environmentally proper manner.
• If the remote control gets wet, wipe it dry immediately.
• Avoid excessive heat and humidity.
• Ensure the battery polarity (+/-) is properly aligned.
• Replace the battery as soon as it runs out.
• Remove battery from the remote control when storing or not in use for a prolonged period.
INF6501a Hardware Guide
30˚ 30˚
Page 9