Saw Stand Assembly; Folding Built-In Legs; Deploying Built-In Legs - Sawmaster M1030 Owner's Manual

Saw Stand Use
WARNING: The following steps should be done
on a stable dry flat surface.
WARNING: Lock the table before proceeding to
prevent damage or bodily harm from sudden
movement of the table.

FOLDING BUILT-IN LEGS

1a. It is recommended that adjusting the folding leg be
done by at least two people.
2a. Remove the detachable wheel assembly from the
legs and stow it on the frame. (see figure 2)
3a. Starting from the rear, the end where the motor is on,
lift the saw up.
4a. Working on one leg at a time, have another person
remove the safety pin and loosen the wing screw. If
the wing screw is stuck, shake the leg to un-stick the
wing screw. With the leg loose, slide the leg from
"setup 2" to "setup 1" position as shown in figure 2.
Retighten the wing screw.
Perform step 4a on the other leg on the same end.
5a.
Place the rear of the saw on the ground. The wheel's
6a.
should be touching the ground.
Perform steps 4a-5a again but on the front of the saw.
7a.
No safety pin is involved for the front.

DEPLOYING BUILT-IN LEGS

1b. It is recommended that adjusting the folding leg be
done by at least two people.
2b. Starting from the front, the end opposite from where
the motor is on, lift the saw up using the front lift
handle.
3b. Working on one leg at a time, have another person
loosen the wing screw. If the wing screw is stuck,
shake the leg to un-stick the wing screw. With the leg
loose, slide the leg from "setup 1" to "setup 2" position
as shown in figure 2. Retighten the wing screw.
Perform step 3b on the other leg on the same end.
4b.
Place the front of the saw on the ground. The frame
5b.
should be touching the ground.
Perform steps 3b-4b again but on the rear of the saw.
6b.
7b. Remove the wheel assembly from the frame and
install it on the leg, in the state it was in step 3a.
NOTE: Refer to SUPPLEMENTARY UNPACKING AND ASSEMBLY INSTRUCTION for more details.
Table lock
Folded state
Front lift handle
Deployed state
Setup 1. Screw positions
for folded legs.
Safety pin (2)
figure 2
Detachable wheel assembly installed
on frame
Detachable wheel
assembly installed
on frame
Setup 2. Screw positions
for deployed legs.
Wing screws (4) to
retract or deploy the
folding legs
6