Advertisement
DSO Series User Manual
Appendix B: Accessories for Tenma DSO
Series Oscilloscopes
Standard Accessories
Two 1.2m, 1:1 (10:1) passive voltage probes see
passive voltage probe operating manual
with EN61010-031:
2008
standard.
Rating is 150V CAT II when the switch is in the 1X
position;Rating is 300V CAT II when the switch is in
the 10X position.
One international power cord.
One User Manual
Communications software
(USB/RS-232C)
USB Lead
UT-D06
Appendix C: Maintenance and Cleaning
General Care
Do not store or leave the oscilloscope where the LCD
display will be exposed to direct sunlight for long
periods of time. Caution: To avoid damage to the
oscilloscope or probes, do not expose them to sprays,
liquids, or solvents.
Cleaning
Inspect the oscilloscope and probes as often as
comply
operating conditions require. To clean the exterior
surface, perform the following steps:
1. Remove loose dust on the outside of the oscillo-
scope and probes with a soft cloth. Take care to avoid
scratching the clear glass display filter when cleaning
the LCD.
2. Use a dampened but not dripping soft cloth to clean
the oscilloscope. Remember to disconnect power. Use
a mild cleaner or water. To avoid damaging the
oscilloscope or probes, do not use abrasive chemical
cleaner.
Warning: To avoid short circuit or personal injury
due to the presence of moisture, please ensure the
product is completely dry before reconnecting power
for operation.
96
Advertisement
