Advertisement
MNO MP Q R P S O TS P Q O UV W X V Y
Key points:
Display Type: Vector display fills the spaces
between adjacent sample points. Dots display only
the sample points.
Refresh rate: Refresh rate is the number of times
the digital storage oscilloscope refreshes the wave-
form display per second. The refreshing speed
affects the capability to observe signal movements
Save and Recall
As shown below, the [STORAGE] button in the control
zone is the function key for the save system.
Figure 2-22 Function key for the sampling system
(save).
Figure 2-22
Press the [STORAGE] button to pop out the setup menu
shown below. You can use this menu to save or
recall waveforms and setup documents stored in the
internal memory and USB memory, and to save and
recall waveform documents and setup documents in
the USB storage device.
Operating Procedure:
1.
Press [STORAGE] to go to the type menu. There are
three types to choose from: waveform, setup and
bitmap. Select WAVEFORM to go to the waveform
save menu shown below (see Table 2-18),After
waveform saving, please goes this chapter II REF
(page 34) Menu, see REF operating procedure.
Select SETUP to enter the setup save menu (see
2.
Table 2-20).
3.
Select
BITMAP
to enter the position save menu
(see Table 2-21).
Remark: This feature can only be recalled after
connecting USB Ram.
56
Advertisement
