Ii.g) Feeder; Ii.h) Blow - TECH ST-37 Manual Manual

ST-37 – Instruction Manual
With this function, you can set the blow interval in the sustain mode.
The two menus are used for regulating the furnace while in the sustain
mode. This is to prevent damping of the furnace when the boiler temperature
is over the setpoint value.
ATTENTION:
temperature! In particular, interval in the sustain mode should not be too
short, and operation in the sustain mode should not be too long.

II.g) Feeder

22 o c
C.H.
With this function, you can disable or enable the fuel feeder, depending on its
condition (e.g. in order to damp the boiler).

II.h) Blow

22 o c
C.H.
With this function, you can disable or enable the blow, depending on its
condition (e.g. in order to damp the boiler).
- 8 -
Incorrect settings may cause a continuous increase of the
56 o c
ON
On *
Off
56 o c
ON
On *
Off
Fan Sustain Pause
Feeder
Feeder
Blow