the boiler temperature is over the setpoint temperature. With this function,
you can set the feeder stand-by time (working time is set as constant by
default). Set the burnout pause time according to the type of fuel and boiler
used.
ATTENTION:
temperature! The burnout pause time should not be too short.
II.r) Factory Settings
The regulator has been pre-configured. However, it should be adjusted to
your individual needs. It is possible to return to the factory settings at any
time. By enabling factory settings, all boiler settings that you have made
will be replaced by settings made by the manufacturer. From then on, you can
again set your own operating parameters for the boiler.
22
o
c
C.H.
III. Protections
In order to ensure a safe and faultless operation, the regulator has been
provided with numerous protections. In the case of an alarm, an acoustic
warning is sounded and the display shows an appropriate message.
Press OPTIONS to restore the controller to normal operation.
Incorrect settings may cause a continuous increase of the
56
o
c
ON
No
Yes
Stand-by in Sustain
Factory Settings
TECH
- 17 -