Table of Contents
Advertisement
ST-37 – Instruction Manual
room setpoint temperature has been reached, the central heating pump is
shut off and will be activated again when the room temperature drops below
the setpoint value). However, the boiler is limited in its operation by the
temperature set with the boiler controller. When the room regulator function
is enabled, the display shows the lower-case letter p.
CONNECTING THE ROOM REGULATOR: the room regulator has a two-wire
cable that should be connected to the controller's connection strip, via a
connector marked as room regulator.
ATTENTION:
output.
II.o) Week-Based Regulation
22
o
c
C.H.
With this function, you can program daily temperature changes in the boiler.
Step one:
First set the correct time and date.
Step two:
Set the days (parameters used in the first mode):
- 14 -
no external voltage can be applied to the room regulator
56
o
c
ON
Time
Date
Room Reg
Week-based Reg
Advertisement
Table of Contents
