Table of Contents
Advertisement
INSTALLING THE STAINLESS STEEL HANDLE
This beverage cooler includes a stainless steel handle that is not required to operate this unit. To install
the handle please follow the below instructions:
① Pull away the door gasket in the area where the handle is to
be installed. You can see two designated holes for handle
installation. The gasket is easily displaced by hand, no tools
② Install the handle tightly as shown below with the two
are necessary.
screws, lock washers and flat washers provided. (DO NOT
over tighten as this will cause damage to the handle assembly
③ Replace the door gasket to its original position.
and stainless steel surface of the glass door).
INSTALLING THE CHARCOAL FILTER
To install the charcoal filter, please follow the below instructions:
Place the carbon filter on top the wooden shelf.
The back of the filter has a 3M glue tape which you can
affix to the shelf or the inside of the unit.
OPERATING YOUR WINE & BEVERAGE COOLER
The setting should be operate in the control panel.
(1) Functions of each keys in the control panel.
①Up
Used to raise (warm)the set temperature by 1°C or 1°F. When the screen is flashing, press it once, the
temperature setting is up by 1°C or 1°F , the highest setting temperature is 18°C(65°F). Stop to press any
button for 5 seconds, then the number stop flashing to show the actual temperature of the cabinet.
The controls of your beverage cooler
10
Advertisement
Table of Contents
