Table of Contents
Advertisement
2) Insert M10 expansion bolt into hole, and then set the iron nail into bolt. As shown in
Fig.4.1.10, and then remove the paper pattern.
NOTE!
The length of bolt should be selection according to the height of room. Bolt should be purchased
by the user.
(2) Install the Mode Exchange Box temporarily
Assemble suspension bolt on the expansion bolt, attach the hanger bracket to the suspension
bolt. Be sure to fix it securely by using a nut and washer from upper and lower sides of the hanger
bracket. The washer fixing plate will prevent the washer from falling.
Fig.4.1.8
Fig.4.1.10
Fig.4.1.11
12
GMV6 HR Mode Exchange Box
Fig.4.1.9
Unit：mm
Unit：mm
Advertisement
Table of Contents
