Tractor Shaft - Schulte FX-107 Operator's Manual

Tractor Shaft

Cross Journals - 2-3 pumps every 8 hours
Lubricate until grease purges from underneath all four needle bearing caps
Shield Retaining Bearings - 2-3 pumps every 8 hours
Rapid Fit Yoke - 2 pumps every 8 hours
Constant Velocity Body - 15-20 pumps every 8 hours
Telescoping Tubes - 2-3 pumps every 8 hours. Occasionally (monthly) pull the universal joint halves apart and
apply grease to all sides of the shaft. At least once per year (more often in dusty or dirty conditions) the
shielding should be removed and the old grease wiped from the shaft. Do not use an alcohol or acid based
solvent to remove the grease. A fresh coat of grease should be applied to the entire surface of the inner tube.
If sliding members are allowed to dry out to the point where the two halves cannot slip
freely, damage to the rotary cutter or tractor may occur.
IMPORTANT: Scan this QR Code with your smart phone to link to the ADMA
Driveline Safety Manual for more information on the safe use of a driveline during
normal operation and maintenance. Or type in your internet browser the following
web address: www.algqr.com/dme
FX107 07/19
© 2019 Alamo Group Inc.
MAINTENANCE
Ops-0009-MISC
Maintenance Section 5-8