Crossing Ditches And Steep Inclines - Schulte FX-107 Operator's Manual

Do not operate this unit at full PTO speed when making a turn greater than 45. A serious
driveline failure or PTO shaft failure could result. Always reduce engine speed when making
sharp Turns.
To avoid overturns, drive the tractor with care and at
safe speeds, especially when operating over rough
ground, crossing ditches or slopes, and turning
corners. Tractor wheel tread spacing should be
increased when working on inclines or rough
ground to reduce the possibility of tipping.
Use extreme caution when operating on steep
slopes. Keep the tractor in a low gear when going
downhill. DO NOT coast or free-wheel downhill.

9.8 Crossing Ditches and Steep Inclines

When crossing ditches with steep banks or going up
sharp inclines, it is possible that the main driveline
inner profile will penetrate into the outer housing to its
maximum depth until the assembly becomes solid
(driveline is at its extreme shortest length). This type
of abusive operation can cause serious damage to
the tractor and mower drive by pushing the PTO into
the tractor and through the support bearings or
downward onto the PTO shaft, breaking it off.
Damage resulting from over-collapse of the driveline's inner profile and its outer housing
may allow the driveline to come loose from the Tractor which could cause bodily injury to the
operator or bystanders and/or extensive damage to the Tractor or Implement. OPS-R-0020
FX-107 07/19
© 2019 Alamo Group Inc.
OPERATION
Operation Section 4-28