Table of Contents
Advertisement
OPERATION
SWITCHING ON/OFF
1. T switch on, slide the switch to the
left towards the 'ON' position.
• When switching 'on', ensure the
polisher is in contact with the
surface to be polished and only
switch it 'off' after removing it
from the surface.
• Excess polish maybe thrown out
during operation.
2. To switch off, slide the switch to
the right towards the 'OFF' position.
3. After use disconnect the tool from the power supply.
HINTS AND TIPS
1. Do not use excess pressure on this machine.
2. Apply the polish directly onto the bonnet, not the work surface.
3. Apply the polish with the applicator bonnet and use the polishing bonnet
to buff the surface to a good shine.
4. Do not use any abrasive materials when polishing.
MAINTENANCE
1. Wash the bonnets after each use by hand and use mild soap with water.
Hang them up to dry. Store them flat and allow them to regain shape.
2. The motor must be correctly ventilated during operation. For this reason
avoid blocking the air inlets. If the supply cable needs replacing, this has to
be done by the manufacturer or his agent in order to avoid a safety
hazard.
3. Keep the surface of the unit free of grit, dirt, and grease. Use soapy water
or non-toxic solvents. Do not use toxic solvents or thinners.
4. Keep the air vents free of foreign matter at all times.
5. If the motor does not operate, it needs to be serviced or replaced by a
qualified technician, contact the Clarke international service department.
Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com
7
Advertisement
Table of Contents
